Bosch GBH18V-34CQ Instrucciones De Funcionamiento Y Seguridad página 13

Note: If after opening the chuck
completely you hear a ratcheting sound
when closing, simply open it a quarter
turn and then resume closing the chuck.
The ratcheting sound will stop.
To remove an accessory, hold chuck
collar with one hand and rotate chuck
sleeve in direction of arrow C with the
other hand until the accessory can be
removed (Fig. 9).
Depth Gauge
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
Setting depth: After the auxiliary handle
is installed, make sure the accessory has
been fully inserted into the tool holder
before setting the depth gauge (Fig. 10).
To adjust depth, push the depth gauge
release button 15, slide the depth gauge
16 to desired depth X and release
pressure on button to lock the depth
gauge in place.
Connectivity Module
Installation (sold separately)
operating instructions included with
Bosch connectivity module. Operating
instructions for connectivity module
include important information not
covered in this manual.
If connectivity module is not purchased
with the tool, or if the replacement of
the module or the battery becomes
necessary, please follow this procedure
(See Fig. 11):
- Using a flat screwdriver or a coin,
remove the cover A from the side of
the handle, by turning it 1/8 turn
counter-clockwise (Fig. 11 or 12).
- If the tool is already equipped with
the connectivity module, remove the
battery B, but do not remove the
connectivity module C.
- If the connectivity module is installed
for the first time, remove the plastic
placeholder D from the connectivity
module compartment, and place the
connectivity module C in the
compartment observing correct
orientation (Fig. 12). Note: Store the
placeholder D in a safe place.
Assembly
To reduce the risk of
injury read
Fig. 10
Fig. 11
the
Fig. 12
Reinsert the placeholder again if the
communications module is removed.
- Next place new battery B on the top
of the connectivity module with the
"+" polarity facing up (Fig. 11).
- Place the cover A over the battery
and turn it ⅛-turn clockwise to lock
using a flat screwdriver or a coin.
-13-
15
1
X
16
A
B
C
A
D