Jensen Phase Linear Serie Instruccionnes De Instalación

Wiring Diagram
IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have
the installation handled by an experienced technician.
Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.
Antenna
15 Amp Fuse
15A
NOTE: When replacing a
fuse, make sure the new
fuse is the correct type
and amperage. Using
an incorrect fuse could
damage the radio. This
head unit uses one 15
amp fuse located below
the wiring connector (15
Dark Blue
amp fast blow ATO).
Black
Grey
Yellow
RCA Outputs to Amplifi er
Red
Left Front Speaker
White/Black (-)
Grey/Black (-)
White (+)
Grey (+)
Left Rear Speaker
Violet/Black (-)
Green/Black (-)
Green (+) Violet (+)
Subwoofer
Output
iPod/jLink connector
Use this 8-pin DIN socket to
connect your jLink iPod cable.
Power Antenna (dark blue wire) Connect
to the power antenna or an amplifi er. If not
used, tape the bare end of wire.
Ground (black wire)
Connect to the ground terminal or a
clean, unpainted part of the chassis.
Memory/Battery (yellow wire)
+
Connect to the battery or to a 12 volt
power source that is always live. The radio
will not work if this wire is not connected.
Accessory/Ignition (red wire)
Connect to the existing radio wire or radio
fuse.
iPod
Right Front Speaker
jLink
iPod Cable
Right Rear Speaker
What's in the Box
• BT1613 Head Unit
• Cosmetic Trim Ring
• Wiring Harness Power/Speaker
• Mounting Hardware
• Remote Control
• jLink iPod Cable
• 3.5mm Media Cable
• Owners Manual
• Installation Guide
WARNING! Never install this unit where operation and viewing could interfere with safe driving
conditions.
BT1613
PS/AS
Tools and Supplies
You will need these tools and supplies to install your
BT1613:
• Torx type, fl at-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver,
socket wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
Installation Guide
BT1613
SERIES