Craftmade Kona Bay K52 Manual Del Usuario página 6

11
5 Blade Installation
Remove rubber cushions, saving
motor screws for blade installation.
Using motor screws (S5) provided,
line up holes from the blade arm with
the holes in the motor housing. Tighten
screws securely.
Step 11
12
1. To install the Switch Housing Assembly (#8), locate both modular wiring
plugs (A) and (B). One extends from the mounting plate (E) on bottom of
fan body and one extends from the Switch Housing (#8). Align the two
plugs so the latch on the side of the plugs will engage when pushed together.
Push the two plugs firmly together until latched.
2. Locate switch housing screws (S9). Raise switch housing cover (#8) and
align the mounting holes with the holes on mounting plate (E). Once the
holes are aligned, attach the switch housing cover using the switch housing
screws (S9) and tighten firmly.
12
Screws (F)
Mounting Slots (D)
IMPORTANT: Be sure that no wires are caught
in mounting slots or pinched between switch
housing and mounting plate.
Step 12
10
Mounting Plate (E)
Modular Wiring Plug (A)
Modular Wiring Plug (B)
Switch Housing (9)