Craftmade Kona Bay K52 Manual Del Usuario página 5

8
1. Connect fan wires to ceiling wires: white fan wire to white outlet wire,
black to black and green to green. Wire connectors (S6) are provided for
your convenience. If an additional blue wire is present then also connect the
blue wire to the black wire. (Optional light kit may be wired to individual
wall switches, if desired.)
2. After connections
Ground
are made, turn
splices upward
White (Neutral)
and push carefully
into outlet box.
Black (Power)
Separate blue and
black wires on one
side of the box, and
white and green wires
on the other side.
There are 4 colored
wires coming from the
top of the motor
(including ground wire).
Wire Connnections
Outlet Box Fan wires
Black Black
(Hot wire for fan)
Green Green
(Ground wire)
White White
(Neutral wire)
Black Blue
(Light kit wire)
Step 8
White
Black
Blue
Outlet Box
Ground (Green)
Downrod Ground
(Green)
Mounting Bracket
Ground (Green)
9
Attach canopy (3) to the
mounting bracket by placing
screws (S2) into slot in canopy.
Twist clockwise to lock
into place. Tighten screws firmly.
Wire
Connectors
(S6)
Ground
(Green)
10
For blade assembly, position blade holder (6), blade (7) so that all screw
holes are aligned (as shown in figure below). Using blade screws (S4), insert
through top of blade holder, through blade, and into blade ornament.
Tighten securely.
Blade Holder
Screws (S5)
CAUTION:
Install blade holders to motor only after motor installation is complete. This will
prevent damage to the blade holders which have been carefully balanced.
IMPORTANT: Remove rubber cushions, saving motor screws for installation.
Step 9
Step 10
Blade Screws (S4)
Blade Arm (6)
Ceiling
Canopy (3)
Screws (S2)
Bottom of Canopy
Blade (7)