Gas Burners; Switching On Manually; Switching On Automatically; Safety System - Gaggenau CG 270 Instrucciones De Uso

Gas burners

There are indications to show which burner each
control knob operates.
It is essential to ensure that all the burner parts and
pan supports are correctly installed for the appliance
to work correctly. Do not swap the burner caps
around.

Switching on manually

1 Press the chosen burner control knob and turn it
anticlockwise to the required setting.
2 Use any type of lighter or flame (cigarette lighter,
matches, etc.) and bring it close to the burner.

Switching on automatically

If your hob can be switched on automatically (ignition
sparkers):
1 Press the chosen burner control knob and turn it
anticlockwise to the maximum power setting.
While the control knob is still pressed down,
sparks are produced on all burners. The flame
ignites.
2 Release the control knob.
3 Turn the control knob to the required setting.
If it does not come on, turn the control knob to the off
setting and repeat the steps above. This time, press
and hold the control knob for longer (up to 10
seconds).
m
Risk of deflagration!
If after 15 seconds the flame does not ignite, switch
off the burner and open a nearby window or door.
Wait at least one minute before trying to switch the
burner back on.

Safety system

Depending on the model, your hob may have a safety
system (thermocouple) that prevents the flow of gas if
the burners accidentally switch off.
To ensure that this device is active:
1 Switch on the burner as usual.
2 Without releasing the control knob, press and
hold it down firmly for 4 seconds after lighting the
flame.

Switching off a burner

Turn the corresponding control knob clockwise to the
0 setting.

Power levels

The progressive control knobs can be used to control
the power needed, from minimum to maximum power.
Setting 0 Control knob off
'
High flame Maximum capacity or aperture and elec-
tricity on
'
Low flame Minimum capacity or aperture
15