Idiomas disponibles
Idiomas disponibles
Ethernet module XPICO Lantronix
default settings: Baud Rate 115200,
Data Bits: 8, Parity: None, Stop Bits: 1
J6: RESET (Reboot the module)
J7: INIT (reset to factory default settings
When the reader is switched on, the module Led stays lit indicate the power supply.
The reader then waits for command. More details about reader's communication are available in the protocol specification SSCP:
Spec_Protocole_SSCP_INDUS_UHF_VX.X_US.pdf.
Mount with a 75 x 75 mm / 0.79 x 0.79 in VESA standard
mounting bracket M4x12 stainless steel screws provided
with mounting kit)
Or mount directly on a wall
Ø4x35 screws provided (VIS-TCZ M4x124x12)
SPECTRE UHF EXTREM
Installation procedure
Configuration of the interface board SME / SLE
Communication protocol SME / SLE
© STid - 20 PA des Pradeaux FR13850 Gréasque – NI1142X01 - Page 2 sur 12 - Ed. 24/07/2020
UHF SPECTRE EXTREM
Notice d'installation
Dimensions (mm/in) - SME
Mounting - SME
Two mounting possibilities:
Adjustable wall-mounted kit
(refer to the Installation Procedures
for KFX-UHF-08)
Wall
UHF SPECTRE EXTREM
Manual de instalación
End-of-line resistor (J8)
Use it (on RS485 connections) when the
data cable is 100 meters or more long,
and the communication is degraded
(polluted signals, frame errors etc.).
Adjustable pole-mounted kit
(refer to the Installation Procedures
for KFX-UHF-09)
US
FR
ES
Pole
