Installation And Use; Safety Instructions; Use - Casselin CSPM Manual De Instrucciones

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
Installation:
- Installation must be carried out by a certified professional.
- The device must be completely removed from its packaging. All protections must be completely removed.
- Place the appliance upright on a solid, flat surface. Never place the appliance on a flammable surface.
- Do not install this device near open fires or other heating devices.
- It is forbidden to place inflammable objects on the appliance or within a distance of less than 10 cm from
the appliance.
Safety distances for flammable materials according to their degree of flammability:
A non-flammable
B hardly flammable
C1 poorly flammable
C2 medium flammability
C3 easy flammability
- The electric cable must be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip.
- When the appliance is placed against a wall, it must be able to withstand a temperature of 80 ° C. If this is
not the case it is essential to insert a protective layer.
- Make sure that all ventilation openings are not blocked.
- Thoroughly clean all parts of the appliance before using it with a suitable product. The control box must
not come into contact with water or humidity.
- Place your appliance under an extractor hood.
- Make sure that the device is placed in such a way that the user has enough space to operate it.
NOTE
The appliance should not run for more than 15 minutes continuously, after a short break the slicer can be
switched on again.
granite, sandstone, concrete, bricks, ceramic tiles, plaster.
acumin, heraclitus, lihnos, itaver
wood from feillus trees, plywood, hardened paper, umakart
chipboard, solodur, cork, rubber, coatings
wood fiber boards, polystyrene, plyurethene, PVC
EN