Replacing A Fuse - TECshow NAVIGATOR SPLIT 8 Manual De Usuario

8. MAINTENANCE
The Navigator Split 8 requires almost no mainte-
nance. However, you should keep the unit clean.
Otherwise, the fixture's light-output will be sig-
nificantly reduced. Disconnect the mains power
supply, and then wipe the cover with a damp cloth.
Do not immerse in liquid. Wipe lens clean with
glass cleaner and a soft cloth. Do not use alcohol or
solvents. Keep connections clean. Disconnect elec-
tric power, and then wipe the connections with a
damp cloth. Make sure connections are thoroughly
dry before linking equipment or supplying electric
power.
The operator has to make sure that safety-relat-
ing and machine-technical installations are to be
inspected by an expert after every four years in the
course of an acceptance test. The operator has to
make sure that safety-relating and machine-tech-
nical installations are to be inspected by a skilled
person once a year.
The following points have to be considered during
the inspection:
1. All screws used for installing the device or parts
of the device have to be tightly connected and
must not be corroded.
2. There may not be any deformations on hous-
9. TROUBLESHOOTING
This troubleshooting guide is meant to help solve
simple problems. If a problem occurs, carry out the
steps below in sequence until a solution is found.
Once the unit operates properly, do not carry out
following steps. If the light effect does not operate
properly, refer servicing to a technician. Response:
Suspect two potential problem areas: the power
supply, the fuse.
1. Power supply. Check that the unit is plugged
ings, fixations and installation spots.
3. Mechanically moving parts like axles, eyes and
others may not show any traces of wearing.
4. The electric power supply cables must not
show any damages or material fatigue.

Replacing a Fuse

Power surges, short-circuit or inappropriate elec-
trical power supply may cause a fuse to burn out.
If the fuse burns out, the product will not function
whatsoever. If this happens, follow the directions
below to do so.
1. Unplug the unit from electric power source.
2. Insert a flat-head screwdriver into a slot in the
fuse cover. Turn the screwdriver to the left,
at the same time gently push a bit (Turn and
Push). The fuse will come out.
3. Remove the used fuse. If brown or unclear, it is
burned out.
4. Insert the replacement fuse into the holder
where the old fuse was. Reinsert the fuse cover.
Be sure to use a fuse of the same type and spec-
ification. See the product specification label for
details.
into an appropriate power supply.
2. The fuse. Replace the fuse. See replacing fuse.
3. If all of the above appears to be O.K., plug the
unit in again.
4. If you are unable to determine the cause of the
problem, do not open the Navigator Split 8, as
this may damage the unit and the warranty will
become void.
5. Return the device to your Showtec dealer.
English version | Tecshow Navigator Split 8
P. 11