Tabla de contenido
(Model PS-2470, PS-3100)
(Model PS-2360, PS-2250)
1
35
(Model PS-2470, PS-3100)
4. Slide the sewing speed controller to its maximum (as far to the
5. Push the Start/Stop button. The machine will stop automatically
6. After the bobbin has stopped moving, push the Start/Stop button
CAUTION
When removing the bobbin, do not pull on the bobbin winder
1
seat. Doing so could loosen or remove the bobbin winder seat,
resulting in damage to the machine.
7. Cut the thread, slide the bobbin winder shaft to the left and
(Mode PS-2360, PS-2250)
4. Step down on the foot controller to start.
5. After the machine stops automatically when the bobbin is full,
CAUTION
When removing the bobbin, do not pull on the bobbin winder
seat. Doing so could loosen or remove the bobbin winder seat,
resulting in damage to the machine.
6. Cut the thread, slide the bobbin winder shaft to the left and
NOTE:
The needle bar does not move when the bobbin winding shaft is slid
to the right.
Immediately after winding the bobbin, it is normal to hear the sound
of the clutch engaging when beginning to sew or manually turning
the balance wheel.
2
right as possible).
when the bobbin is full.
to stop the machine.
1 Sewing speed controller
remove the bobbin.
take your foot off of the foot controller.
remove the bobbin.
CAUTION
Be sure to follow the process described. If the thread is not
cut completely, and the bobbin is wound, when the thread
runs low it may tangle around the bobbin and cause the
needle to break.
CAUTION
Setting the bobbin improperly may cause the thread ten-
sion to loosen, breaking the needle and resulting in injury.
1 Wound evenly
2 Wound poorly
Tabla de contenido
