Safety Measures; Beams Protection; Chimney - Bio Bronpi NEVA Instrucciones De Instalación, Uso Y Mantenimiento

• Avoid the installation in places where there are collective ventilation pipes, hoods with or without extractor, B type gas equipments,
heat pumps or equipments that can cause that the draw is not good if they are used at the same time.
• Make sure that the smoke duct and the pipes used for the chimney are suitable for the operation of the insert.
• Make sure that every equipment has their own smoke duct. Do not use the same duct for several equipments.
We recommend that you call your fitter in order to check both the chimney as well as the air flow for the combustion.
5.1

SAFETY MEASURES

During the installation of the equipment, there are risks to be taken into account, so you should follow the next safety measures:
a. Keep any flammable or heat sensitive materials (furniture, curtains, and clothing) at a minimum distance of about 150cm.
b. If the equipment is installed on a floor which is not completely refractory or inflammable it is necessary to replace this part or introduce
a fire-resistant base.
c. Do not place the stove near combustible walls or likely to be affected by a thermal shock.
d. The stove should only be used when the ash pan is inserted and the door closed.
e. It is recommended to install carbon monoxide detector (CO) in the room where the equipment is installed.
f. If you need a longer wire than the provided use it always with an earthed plug.
g. Do not install the stove in a bedroom.
h. The appliance should never be turned on in the presence of emission of gases or vapours (e.g., linoleum glue, gasoline, etc). Do not
place nearby flammable materials.
i. Solid combustion residues (ashes) should be collected in an airtight container and resistant to fire.
j. It is necessary to keep a safe distance when they are installed in spaces where materials are susceptible of being flammables, either
the constructions materials or different materials that surround the stove (see drawing D7).
REFERENCES FLAMMABLE
A
B
C
WARNING!! It is noted that both the stove and the glass get
very hot and should not be touched.
In case of is fire in the stove or smoke duct:
a. Close the loading door.
b. Put the fire out by using carbon dioxide extinguishers (CO2
powder).
c. Request for the immediate intervention of the fire-fighters.
DO NOT PUT OUT THE FIRE WITH WATER
5.2

BEAMS PROTECTION

In model Neva, due to the amount of heat produced by the device, you have to pay special attention to protect nearby wooden beams. When
you design your fireplace or coating both the proximity of the beams to the exterior surfaces of the fire, and the heat emitted from the glass
door need to be taken into account. The exterior faces of combustible
beams must not be subjected to temperatures exceeding 65ºC.
Some suggested solutions to this matter appear on drawing D8.
1. Beam:
2. Refractory material isolation;
3. Pothole;
4. Metallic protection
WARNING:
The manufacturer declines any responsibility for the malfunction of an
installation not subject to the requirements of these instructions or the
use of additional products not appropriate.
5.3

CHIMNEY

The chimney is very important for the proper operation of the stove and it has two functions:
• Evacuate the smoke and the gas safely out of the house.
• Provide a draft enough to the stove or insert.
The draft also affects the intensity of the combustion and the heating performance of your equipment. A good draft of the fireplace needs a
reduced regulation of the air for the combustion, while a lack of draft needs a good regulation of the air for the combustion.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
NON-FLAMMABLE
ITEMS ITEMS
1500 800
1500 150
1500 400
C
(1)
(3) 10 mm
(2)
(1)
(3) 10-50 mm
(3) 10 mm
(2)
27
A
2
80-120 cm
Floor covering
(1)
(3) 10 mm
(3) 10 mm
(2) (2)
(4)
(1)
(3) 10 mm
(2)
(2)
RADIOFREQUENCY SERIES
B
D7
(1)
(1)
(4)
D8