HTC HGP-10 Manual Del Operador página 3

Assembly Instructions
All units in the Heavy Duty Pedestal Family will start with the assembly of the basic pedestal. Tools needed: (2) 7/16''
wrenches and a putty knife.
1. Unpack and make certain all parts and hardware are included and are
not damaged from shipment.
2. Attach each foot to the Main Tube, using (2) 1/4"‑ 20 x 3/4" bolts, installed
through the face of the part, then through the holes in the Main Tube. Secure
with (2) 1/4" Lock Washers and (2) 1/4" Hex Nuts from the inside of the tube.
Be sure the threaded boss for the Leveling Glide will face down when the unit is
fully assembled, and the short leg of the foot is positioned as shown. Repeat the
procedure on the remaining 3 feet.
3. Once all 4 feet are attched to the Main Tube, join them together by inserting a 1/4"‑
20 x 3/4" Hex Bolt through the hole in the short leg of the foot, through adjoining
foot, and secure with 1/4" Lock Washer and Hex Nut.
4. Install the Leveling Glides and adjust as needed.
5. Install the Crank Handle into the Main Tube.
6. Inset the Wedge into the Main Tube.
HGP-10 Assembly
1. Attach the top mounting plate to the wedge with (2) 5/16" ‑ 18 x 2‑1/4" carriage bolts from the bottom with flat
washer, lock washer, and hex nut on top. Pre‑plan the carriage bolt locations for mounting user supplied grinder. Flat
washers (2), hex nuts (2) and jamb nuts (2) are supplied to secure grinder. Flat washers (2), hex nuts (2) and jamb
nuts (2) are supplied to secure grinder.
HGP-12 Assembly
1. Attach the top mounting plate to the wedge with (2) 5/16" ‑ 18 x 1" Allen bolts, washer, lock washer and 5/16" ‑ 18
Hex nut.
HRT-8/10, HSS-15/18, HVR-15/18 and HSV-15/18 Assembly
1. Attach Top Bracket to 5006 wedge using 5/16" ‑ 18 x 1" Allen bolt, washer, lock washer and 5/16" ‑ 18 Hex nut.
2. For model numbers with rollers, use a putty knife like a shoehorn, insert the fixed end of the roller into the bracket
and "snap" the spring‑loaded end into place.
3