Vacuum Maintenance And Care - KENMORE ELITE SSV | Quick Clean DS6025 Manual De Uso Y Cuidado

VACUUM MAINTENANCE AND CARE

CAUTION
To reduce the risk of electric shock, turn power off and remove the unit from the
charging dock before any maintenance.
EMPTYING DUST CUP AND FILTER CLEANING
For best performance, empty dust cup
after every use or once dust reaches max
fill line. Never operate vacuum cleaner
without dust cup and filter in place.
Before emptying the dust cup, ensure the
vacuum is turned off.
1. Position dust cup area of vacuum over
a waste receptacle. Press down on the
dust cup release button to open dust cup
lid and allow cup contents to drop into
waste receptacle.
Dust Cup
Release Button
2. If necessary, clean off
hair and other debris
wrapped around the
pre-filter. Rotate pre-
filter clockwise to
remove from dust cup
chamber for cleaning.
3. Insert pre-filter back into chamber and
rotate as shown below to lock. Close
dust cup lid until you hear a click.
After repeated use, it is necessary to wash
the HEPA filter and 2 foam filters clean of
accumulated dust.
WARNING:
cleaner without filters in place.
1. Open the filter cover on top of hand
2. Brush loose debris
IMPORTANT:
filters must dry completely before reuse.
3. Place the small foam filter back into the
ON OFF
Small
Filter
Click
- 14 -
Do not operate vacuum
vacuum by squeezing the two release
buttons inward and lifting off. Remove
HEPA filter and small foam filter from
forward area of filter chamber. Remove
round foam filter from inside of HEPA.
from HEPA filter
and then rinse with
warm water. Rinse and gently squeeze
dry the foam filters. Set all filters aside
and allow to air dry.
The HEPA and 2 foam
front of the filter chamber.
Place the round foam filter into the
center of the HEPA filter. Insert the HEPA
filter into filter chamber and reattach
filter cover.
Round Foam
Filter
HEPA Filter