Mc Haus artic-16 Manual Del Usuario página 42

OPERATION
1. Mode COOL:
• When the device is on or the timer is on, press MODE to select the COOL mode. At this time the
mode indicator light is displayed.
• Press ▲/▼ to set the appropriate temperature in the range of 16-30°C.
• Press the SPEED key to choose High/Medium/Low speed.
2. Mode FAN:
• When the unit is on or the timer is on, press MODE to select FAN mode. At this time the
corresponding indicator light will activate.
• Press the SPEED key to select the High/Medium/Low speed.
• The temperature is not adjustable.
3. Mode DRY:
• When the unit is on or the timer is on, press MODE to select DRY mode.
At this time the corresponding indicator light will activate.
• Temperature and speed are not adjustable.
• Remove the drain plug (Fig.4) and insert a pipe/hose that leads to a
water tank or channel.
• If the ambient temperature is above 17°C the compressor will start and
if it is below 15°C the compressor will stop.
WARNING! When the DEHUMIDIFY function is used, the components
must be removed from the outlet pipe, otherwise it will cause a worse
dehumidification performance, and the water fill alarm "FL" will appear.
4. Mode TIMER :
• In standby mode, press the TIMER key to set the power on time. Press the ▲ and ▼ keys to set the
power on time (0~24H), and the timer indicator light will light up.
• In the ON state, press the TIMER key to set the off time. Press the ▲ and ▼ keys to set the time
(0~24H), and the timer indicator lamp will light up.
DRAIN OPERATION
If the internal container is full of water, the display screen will show "FL", and the engine will stop
running automatically. To drain the water, disconnect and disassemble the air exhaust pipe,
remove the water and replace the cap (Fig.5). Before restarting, replace the exhaust pipe.
WARNING! When the water tank is full, please move the air conditioner firmly,
otherwise the water may overflow from inside.
Mc HAUS
artic-16
4
5