Speedaire 6Z899B Manual De Instrucciones De Operación página 2

Speedaire Operating Instructions and Parts Manual
Speedaire
General Safety Information
(Continued)
spray guns are secure before turning
air supply on.
8. Release all pressure within the
system before attempting to service
E
any component.
N
9. Protect material lines and air lines
G
from damage or puncture.
L
10. Never point a spray gun at yourself
I
or at any other person. Accidental
S
discharge may result in serious
H
injury.
11. Check hoses for weak or worn
condition before each use, making
certain that all connections are
secure.
12. Always shut off air pressure at
source and bleed off all pressure in
paint tank by gently pulling safety
valve ring before loosening knobs.
13. Regularly check to be sure gauge
and regulator are functioning
correctly. Also check that no paint or
other deposits are in the safety valve
inlet. In the event more than 50 psi
is applied to the tank and the safety
valve is clogged, the higher pressure
could damage the tank or result in
injury.
Do not spray flammable
materials in vicinity of
open flame or near ignition
sources including the
compressor unit.
14. Do not smoke when spraying
paint, insecticides, or other
flammable substances.
15. Use a face mask/
respirator when
spraying and spray in a
well ventilated area to
prevent health and fire
hazards.
16. Do not direct paint or other
sprayed material at the compressor.
Paint Tank
®
Locate compressor as far away from
the spraying area as possible to
minimize overspray accumulation on
the compressor.
17. When spraying or cleaning
with solvents or toxic chemicals,
follow the instructions provided by
the chemical manufacturer.
Failure to follow
instructions on
proper assembly and use of a paint
tank may possibly result in damage to
property or personal injury. This unit
must be assembled as indicated in these
instructions. Only parts supplied with
this unit should be used. These parts
are safety performance engineered. Use
only OEM replacement components.
Assembly
NOTE: Use PTFE thread sealant tape or
thread sealant on all connections.
1. Assemble the regulator to the paint
tank lid as shown in Figure 1:
Pipe nipple
Figure 1
a. With arrow pointed down and
knob toward you, place the gauge
in the left 1/8 NPT regulator port.
b. Assemble the 1/8 plug into
opposite 1/8 NPT regulator port.
c. Thread the 1/4 T-fitting into the
top 1/4 in. regulator port.
d. Thread 1/4 in. pipe nipple into
bottom 1/4 in. regulator port (with
arrow).
e. Thread this assembly into the #3
1/4 NPT port on tank lid.
2
NOTE: This regulator is a special
pressure limiting regulator. Do not use
any other type of regulator with this
paint tank. Assemble the regulator to
the paint tank only as instructed.
2. Assemble the safety relief valve to
the tank lid port #4.
Safety
relief
valve
Pressure gauge
Figure 2
3. Install the pipe plug into the 1/8 NPT
port #2 of the tank lid.
4. Thread the handle into the center
port of the tank lid.
5. Install hose connector in tank lid
port #1 from the top.
6. The material tube is pre-assembled
to port #1.
7. To assemble tank bracket with knob
assembly:
a. Lay out tank bracket to form circle
b. Insert eyebolt between each
c. Flip tank upside down and slip
d. Slide bracket down to rim and
6Z899B
Handle
Hose
connector
Pipe plug
Material
tube
(4 sections).
section, slip hex bolt through
holes and loosely screw on stop
nuts.
bolted bracket assembly around
tank.
tighten all nuts.