Westfalia 305 223 Instrucciones De Montaje página 19

Installation instructions: (Audi A3)
1.) Remove the rear bumper cover. To do this first detach the screws in the wheel bases at right and left (3 apiece). Then detach the
screws at left and right in the loading space opening of the boot and remove the covering, which is affixed with Velcro tape. Detach the
screws located under this (6 in all) and remove the fixture plate. Remove the bumper covering in backwards direction.
2.)
Remove the rear aluminium bumper. To do this detach the two hexagon screws respectively at right and left. The hexagon screws
and the aluminium bumper are no longer required.
3.) Remove the linen adhesive strip on both longitudinal beams at the left and right of the vehicle at the outside in the area of the
elongated holes at "b". If provided, remove the clips in front of the front mounting points from the longitudinal beams. Treat any open,
metallically polished surfaces with an anti-corrosive (zinc primed, etc.).
Pre-assemble the power outlet and the connecting cable on the towing hitch according to the installation instructions for electrical
4.)
equipment.
5.) From the rear move the side parts of the towing hitch [1] halfway into the longitudinal beams of the vehicle. At the same time guide
the connecting cable through the opening in the tail plate. Install seals into the longitudinal beams at left and right and slide the towing
hitch in until the drill holes at "b" are congruent with the elongated holes in the vehicle.
6.) Install seals [900 002 504 014] from the rear into the longitudinal beams of the vehicle.
7.) Affix the towing hitch at left and right by using the hexagon screws [4] and washers [5] at "b". Tighten all four screws with a torque of
55Nm +5Nm.
8.) Shorten the clips removed in step 3 and re-insert them into their holes.
Installation instructions: (Škoda)
1.) Remove the rear bumper cover. To do this first detach the two rear lights at left and right. Then detach respectively three screws
affixing the bumper in the wheel base, two screws at left and right, a plastic clip at the left and at the right above the bumper, and two
screws from below. Likewise detach the wheel base covering at left and right (removing one screw from below suffices).
2.) Remove the rear metal bumper.
To do this detach the two screws respectively at right and left. The screws and the metal bumper are no longer required.
Move the side parts of the towing hitch [1] so long from the back into the longitudinal beams of the vehicle until holes "a",
3.)
respectively "b", are congruent with the holes in the vehicle. At the same time guide the connecting cable through the opening in the tail
plate.
4.) Fasten the towing hitch at left and right by using the hexagon screws [4] and washers [5] at "a" respectively "b". Tighten all four
screws with a torque of 55Nm +5Nm.
5.) Pre-assemble the power outlet and the connecting cable on the towing hitch according to the installation instructions for electrical
equipment.
6.) Important: If necessary, adapt cut-outs.
7.) Reassemble the complete bumper covering , the rear lights and the wheel housing covering.
8.) Assemble the electrical equipment set completely, using the electrical installation instructions.
Subject to alteration.
Subject to alteration.
19