Replacing The Batteries - ELTRA Profile VIVACE Manual De Instrucciones

4
PROGRAMMING MULTIPLE BUTTONS
A
B
NOTE :
You can programme up to a maximum of 4 buttons on one bell. If you attempt to programme a
fifth button, the bell will play an error signal.
5
RINGTONE CHOICE
B
TIP :
You can change the melody per bell for multiple buttons. Follow the instructions above per button.
6

REPLACING THE BATTERIES

A
BEEP Press the channel selection button at the back of the bell
for 3 seconds. The bell will produce a monotonous sound. It
is ready to read a second signal.
♫ ♫
Within a minute, push the button. The bell will play a ring-
tone. This is now programmed on the button.
Leave it for 5 minutes before reusing it.
♫
To change a ringtone, do as follows:
• Open the button as in step 1A
• Press the "S" button. Your bell will play a new melody with
• The last selected melody will be remembered.
• You can choose between 8 different melodies.
•
Open your button as described in step 1A. Remove the bat-
tery compartment cover using a screwdriver
Insert a 3V battery (CR2032) into the battery compartment
and make sure to note the battery polarity when doing so.
NOTE: the LED of the bell unit will flash in the event of an
empty battery. Always repeat steps 1B-C when replacing the
batteries
each push.