Battery Replacement - RISCO Group EL-5803 Instrucciones De Instalación

DELETING THE SMOKE AND HEAT DETECTOR
1. Set the system to delete mode.
a. Go to the main menu and select [9]>[1]>[1] (Programming > Devices > Zones).
b. Select a zone and press '√'
c. Press >12 >√.
2. Open the detector and remove the batteries.
3. Press the tamper switch. While pressing the tamper switch, re-insert the battery.
4. Within 5 seconds open the tamper and close it again.
SMOKE AND HEAT DETECTOR MAINTENANCE
To keep your detector in good working condition, you must test the detector weekly,
according to the "Testing Your Smoke and Heat Detector" section.
CLEANING THE SMOKE AND HEAT DETECTOR
Clean the detector housing with a dry or damp cloth to remove dust and dirt. If necessary,
open the smoke chamber and clean the interior of the detector.
To clean the detector:
1. Remove the detector from the detector base.
2. Remove the batteries.
3. Use a fine paintbrush to remove dirt from the chamber.
4. After cleaning, close the smoke chamber, secure the housing and re-mount the detector
on the ceiling.
DO NOT FORGET TO REPLACE THE BATTERIES!

BATTERY REPLACEMENT

Replace the detector batteries once a year, or immediately whenever the low battery
"beep" signal sounds once every 35 seconds. The low-battery "beep" should last at least
30 days before the batteries die out completely.
To replace the detector batteries:
1. Remove the detector from the plastic mounting bracket..
2. Open the battery compartment cover.
3. Remove the old batteries.
4. Insert the new batteries while observing battery polarity (see Figure 10), and close the
battery compartment cover.
5. Reconnect the detector to the mounting bracket.
1 & 2-Way Smoke & Heat Detector
EN
13