Instruction Manual - AKO-Agrartechnik BA-1049 Manual De Instrucciones

Operating Instructions
1
2
3
a.) Installation
The fastening hole (5) is used for wall mounting. The appliance must be mounted against a perpendicular, fireproof wall
with the power cable at the bottom, see above figure. For outside installation the device must also be protected against
exposure to rain and direct sunlight.
b.) Functional description of the appliance
Put the appliance into service without fence and earth. If the indicator light (1) flashes at the pulse rate, the appliance is
ready for use.
If the indicator light (1) does not flash, check the supply voltage and/or the power cable. If no fault is found, the appliance
should be checked by a technician.
c.) Functional description with connected fence system ( fence + earth )
5. Connect fence system and earth
6. Insert 230V power cable
Indicator
Function
light (1)
flashes Fence and
3.
green earth OK
Fault:
insufficent
earth
flashes
4.
red
Fault:
Fence system
shorted to
earth
does
Appliance
5. not
NOK
flash
If the indicator light flashes faster than approx. once per second, the appliance must be disconnected at once and
checked by a technician before it can be used again.
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning, warranty terms and
conditions and potential sources of fault!
SERVICE Addresses:
Please contact your specialist dealer
5
Not suited for use in barns!
Connection to
4
Fence voltage
> 2500V
= min. requirement
< 2500 V
= insufficient
230 V
~!
Remarks
Fence system OK!
(prerequisite: fence system not interrupted)
Fault :
Voltage on earth electrode > 1000V
see fault finding in enclosed instruction manual (Figure 2, p. 5)
Fault condition: low fence voltage, no excessive voltage on earth
electrode
Measure voltage on fence: min. value: 2500V throughout the
fence
see fault finding in enclosed instruction manual (Figure 2, p. 5)
See above: b.) Functional check of the appliance
3
Indicator light
1 (flashes to indicate that the
appliance is ready for use)
2 230V ~ power cable
3 Earth connection
4 Fence connection
5 Fastening hole
-EN-
Version : 2014.4