Tabla de contenido
Idiomas disponibles
Idiomas disponibles
BM 2609140889 06-12_BM 2609140889 06-12 6/26/12 10:42 AM Page 9
Disconnect battery pack
WARNING
from tool before making any
assembly, adjustments or changing
accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
INSERTING AND REMOVING
ACCESSORIES
To avoid loss of control,
WARNING
ensure bit is locked in chuck
by pulling on bit after it has been inserted.
The chuck accepts only standard 1/4"
hexagonal shank accessories with power
groove.
Your tool is equipped with a quick release
chuck. To insert an accessory, simply pull
locking sleeve forward, insert desired accessory
into chuck and release locking sleeve (Fig. 2).
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty,
the tool is switched off by means of a
protective circuit.
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger in
WARNING
"OFF" position to help prevent
accidental starts and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 3). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an "OFF" position.
Assembly
Operating Instructions
BRAKE
To remove an accessory, pull locking sleeve
forward and simply remove it from the chuck.
LOCKING SLEEVE
FIG. 2
CHUCK
SCREWDRIVER
BIT
BIT HOLDER
SCREWDRIVER BIT
FORWARD/REVERSING
LEVER & TRIGGER LOCK
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
Do not change direction of
CAUTION
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
-9-
FIG. 3
Tabla de contenido
