Care And Maintenance - D Devices D_ULTRASONIC CLEANING BATH 6L Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34

9. Care and maintenance

Do not turn on the unit without water in the tank. Even though
1.
the unit is designed with multiple protections, if it is turned on for
over 30 seconds without water in the tank, it may damage the unit
or severely reduce the life of the unit.
A thermal switch is attached to the bottom of the cleaning tank.
If the unit is turned on accidentally without water in the tank, the
ultrasonic energy will not be transferred out through the liquid and
instead will be concentrated on the tank, the temperature of the tank
will continue to rise. If the heater is turned on at the same time, the
temperature of the tank will rise rapidly. This will trigger the thermal
switch to cut off power to stop the ultrasonic transducer and the
heater from running, hence to prevent damages to the unit and fire
hazard.The switch cuts off power for approximately 6-10 minutes
then reconnect the power automatically.
Do not run the unit for extended time or continuously. The unit
2.
is designed with overheat protection. If the unit has been running
for 45 minutes, it is recommended to stop the unit for about 20
minutes to prolong the life of the unit.
Do not keep water in the cleaning tank for a long time. After
3.
cleaning is completed, open the drainage valve to drain the dirty
water. Clean and wipe the tank dry.
Do not spray water over the housing. Use a towel to wipe the
4.
tank and the housing dry.
5.
Do not expose the unit under direct sunshine for a long time.
Keep the unit in a dry, cool and ventilated area.
31
Tabla de contenido
loading

Tabla de contenido