Operation Guidelines - D Devices D_ULTRASONIC CLEANING BATH 6L Manual De Instrucciones

8. Operation guidelines

3. Turn the power switch on. Press Temp button
to set the water temperature to 50ºC (122ºF).
Press Heater button to turn on the heater,
flashes. Close the lid. LED
indicating the percentage range of the set tem-
perature being reached. When water reaches
the set temperature,
heater is turned off.
The heater has dual protection. It will be turned
off automatically after 50 minutes.
4. Press Time button to set the timer to 15
minutes.
5. When it is done, remove the basket and the
items. Rinse the items with tap water or follow
steps 6 and 7 in the Enhanced Cleaning section.
During cleaning, debris will come off the items like
"smoke". Water will become murky. This method
will remove silver or copper oxidation and debris in
the decorating patterns and crevices and make the
items like new again.
1. Remove the cover and put it on the cover hol-
der vertically. Put items in the basket then put
them in the cleaning tank. Add water to a level
between MIN and MAX and above the area to
be cleaned.
If the unit is turned on without water,
ultrasonic energy will not be absorbed. This
model also has high power. Once on for over
15 seconds, it may damage the unit or severely
reduce the life of the unit.
2. Connect the power cord to an outlet
and turn the switch on. LED display
shows . This is the most com-
mon timer setting .If the timer needs to
be adjusted, press Time button. Select
desired time setting by pressing Time
button:
10 min 15 min 20 min
Prolonged cleaning time may result in:
a. Loosening of the screws if used.
b. If items are plated and have existing cracks,
the cracks may become more pronounced.
c. Coating with preexisting damages may
experience more peeling.
lights up
dims, indicating the
25 min 30 min 5 min
29