Better Homes and Gardens BH1609239915 Manual Del Propietário página 3

ASSEMBLY INSTRUCTIONS
Step 1.
Identify all parts packed in carton against the parts list. Remove all protective materials. Place parts
on a non-abrasive surface to avoid scratching.
Step 2.
Attach a leg to the leg connector (C) using M6x15 bolts (E) and metal washers (F) as shown in the
diagram. Hand tighten 3-4 revolutions only. Do not tighten completely. Repeat this for another leg.
Step 3.
With the help of another person, place the table top (B) upside down on a flat, non-abrasive surface
to avoid scratching the top or rim. Attach table leg (A) to rim using M6x35 bolts (D) and metal
washers (F) as shown in the diagram. Guide the bolt through the hole in table leg into the pre-drilled
hole in the table rim. Hand tighten 3-4 revolutions only. Do not tighten completely. Some adjustments
may be necessary to ensure proper alignment of the table legs. Repeat this for another leg.
Step 4.
After making any necessary adjustments on the alignment of the table legs and leg connector,
use the hex bolt driver to tighten all bolts. Each bolt must be tightened a few revolutions at a time.
In order to apply equal pressure to all bolt joints, we recommend working in a cross corner ("X")
fashion. Repeat until all bolts are tight. Do not over-tighten, over-tightening may strip bolts.
C
C
B
G
E
F
A
G
E
F
A
1-866-771-2663 | Page 3