Functional Description - Makita BO4552 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see
that the tool is switched off.
• Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply cau-
tion when locking tool in "ON" position and maintain
firm grasp on tool.
To start the tool, press the "ON ( I )" side of the switch. To
stop the tool, press the "OFF (O)" side of the switch.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing abrasive paper
To install the abrasive paper, operate the clamp lever to
open the paper clamp. Insert the paper end into the
clamp. Center the paper and align the edges parallel to
the pad, then lower the clamp lever to secure the paper.
(Prebending paper makes attachment easier.)
Repeat the same process for the other end of the base,
maintaining the proper paper tension.
After inserting the paper, make sure the teeth of the
clamp hold it securely. Otherwise the paper will be loose
003284
1
1. Switch
003306
1. Lever
2. Clamp
1
2
and subject to slippage, resulting in uneven sanding
operation.
Punch plate
3
When using the dust bag, make holes in the abrasive
paper using the punch plate as follows:
1. Set the tool upside down.
2. Place the punch plate over the abrasive paper so
that the bent sides of the punch plate are flush with
the paper edges.
3. Press the punch plate to make holes in the abrasive
paper.
CAUTION:
• Be sure to remove the punch plate before operating
the tool.
Dust bag
1
2
3
The use of the dust bag makes sanding operations clean
and dust collection easy. To attach the dust bag, fit the
bag's entry port onto the dust spout on the tool. Make
sure that the hole in the bag's entry port is just over the
pimple-like protrusion on the dust spout.
For the best results, empty the dust bag when it becomes
approximately half full, tapping it lightly to remove as
much dust as possible.
4
003316
1. Punch plate
1
2. Sandpaper
3. Guide
2
003320
1. Dust bag
2. Hole
3. Protrusion
4. Dust spout
5. Entry port
5
4