Medline MDS86845W Guia Del Usuario página 5

Assembly Instructions
1. Carefully remove the rollator components from the shipping carton.
2. Refer to diagram (Figure 1) as needed.
• 1 Rollator Frame
• 4 Triangular Hand Screws
• 2 Front Wheels
• 2 Rear Wheels (attached to brake cables)
3. Examine all parts for shipping damage. DO NOT use the rollator if there is apparent damage
or if any parts (other than the bag) are missing. If there are missing or damaged parts, please
call Medline Customer Care toll free at 1-800-MEDLINE.
4. Remove plastic cover from the wheels before use.
5. Check all of the wheels to see that they are in good working order and roll freely.
6. Turn the frame over on its side.
7. Unfold the rollator by grabbing a front leg and rear leg and pull them apart.
When inserting and adjusting the legs
and handles, use the following guidance
and the height measurements below.
1. Measure from the ground to the
crease in the back of the knee.
(Dimension A in figure above)
2. Adjust the rollator legs accordingly
so the seat is at same height as
measurement taken above.
3. Keeping arms at your side
with a natural bend at the elbow,
measure from the ground to the
center of the wrist.
(See Dimension B in figure above)
MDS86845 Series (PIC-00311)
Revised: 12/28/2018
B
A
5