Targus AMW841 Guia Del Usuario página 4

AMW841LP-50
Folded Size: 4.5" x 4.5"
Technical Support
For technical questions, please visit:
US/Canada Internet: www.targus.com/support.asp
Australia Internet: www.targus.com/au
Email: [email protected]
Telephone: 1800-641-645
New Zealand Telephone: 0800-633-222
Latin America Email: [email protected]
Product Registration
Targus recommends that you register your Targus accessory shortly after purchasing it.
Go to: http://targus.com/us/product_registration
You will need to provide your full name, email address, country of residence and product information.
Warranty
Targus warrants this product to be free from defects in materials and workmanship for one year. If your
Targus accessory is found to be defective within that time, we will promptly repair or replace it. This
warranty does not cover accidental damage, wear and tear, or consequential or incidental loss. Under
no conditions is Targus liable for loss of, or damage to devices; nor loss of, or damage to, programs,
records, or data; nor any consequential or incidental damages, even if Targus has been informed of
their possibility. This warranty does not affect your statutory rights.
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
6
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
RF warning statement
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
7