Getting Started; Installing The Battery; Checking The Battery - Palmer AHMCTXL Manual De Usuario

INTRODUCTION
The MCTXL cable tester comes equipped to test a wide range of cables and their connectors. Simply plug in
any of following cables and check their functionality:
- 1/8 inch TRS (3,5 mm jack)
- ¼ inch TRS (6.3mm jack)
- DIN plug
- Cinch (Phono, RCA)
- XLR (microphone cable - male/female)
- Speakon 4 pole
- Speakon 8 pole
- USB
- S-Video
- RJ45 (CAT)
- Midi

GETTING STARTED

INSTALLING THE BATTERY

Locate the battery compartment on the rear side of the tester. The screws can be manually unscrewed. Then
install two AA batteries.

CHECKING THE BATTERY

Turn the device on. The first red LED of the LED chain will glow. If this LED lights up strongly the battery is ok.
If the LED is only faintly lit, then the batteries are almost empty and should soon be replaced.
3