Tabla de contenido
Idiomas disponibles
Idiomas disponibles
14 Connect remaining wires from Step 8
Tip: Do not mount the UWP to the wall
prior to connecting the wires.
Depress the tabs to put the wires into
the inner holes of their corresponding
terminals on the UWP (one wire per ter-
minal) until it is firmly
in place.
Gently tug on the wires to verify they
are secure.
Tip: If you need to release the wires
again, push down the terminal tabs on
the sides of the UWP.
15 Mount the UWP and close the door
Mount the UWP using the provided
screws. Install all three screws for a
secure fit on your wall. Close the door
after you're finished.
Use 3x supplied screws
(#8 1-1/2 (38 mm) for
red anchors and
#6 1-1/2 (38 mm) for
yellow anchors)
13
This wiring is just an example,
actual wiring may vary.
Tabla de contenido
