Connecting Euroblock Plugs (Ml-4D/Out-E Only) - Tascam ML-4D/OUT-E Manual Del Usuario

External control connectors
8
(CONTROL, ML-4D/OUT-E only)
By connecting variable resistors between the
GND
and connectors, the selected audio signal levels
can be adjusted.
The 10V connectors are for supplying power to variable
resistors.
(Left is 10V, center is CONTROL and right is GND.)
Gigabit link status indicator
9
Orange indicates that a gigabit Ethernet link has been
established.
Link status/activity indicator
0
Green indicates that a link is established between the
devices.
Blinking indicates that signals are being transmitted be-
tween the devices.
DC IN 12V connector
q
Connect a PS-P1220E AC adapter (sold separately) here.
Cord holder
w
When using a PS-P1220E AC adapter (sold separately),
hook its cord here to prevent accidental disconnection.
Connecting Euroblock plugs
(ML-4D/OUT-E only)
CONTROL
2.5 mm or less
Terminal screw
Euroblock plug tab
1.
Loosen the Euroblock plug terminal screws.
NOTE
Use a flat-blade screwdriver with a width of 2.5mm or
less.
2.
Insert wires.
NOTE
AWG16–AWG28 wires are compatible with the includ-
ed Euroblock plugs. Using wires within the compatible
range, trim about 7 mm of the protective sheaths from
their ends.
3.
Tighten the Euroblock plug terminal screws.
NOTE
Confirm that the wires cannot be pulled out.
4.
Use an included wire band to attach the wires to the
Euroblock plug tab.
Flat-blade screwdriver
Euroblock plug
TASCAM ML-4D/OUT-E / ML-4D/OUT-X
9