Maintenance - RedMax SGCZ2460S Manual De Instrucciones

SGCZ2460S

9. Maintenance

Maintenance, replacement, or repair of the emission control device and
systems may be performed by any non-road engine repair establishment or
individual.
■ MAINTENANCE CHART
system/compornent
fuel leaks, fuel spillage
fuel tank, air filter, fuel filter
idle adjusting screw
spark plug
cylinder fins, intake air cooling vent
muffler, spark arrester, cylinder exhaust port clean
throttle lever, ignition switch
cutting parts
debris guard
gear case
screws/nuts/bolts
• Before cleaning, inspecting, or
repairing the unit, make sure that the
engine has stopped and is cool.
• Use protective gloves whenever
inspecting, removing, sharpening,
and installing the blades.
■ BLADE
MA1
Wipe off dust and dirt attached to the
blades, and oil them after every use.
To Sharpen blade:
1. When the cutting edges have become
dull, sharpen them by using a small disk
grinder. (MA1-a)
2. When sharpening, offset the teeth of
upper and lower blades by 3mm. (MA1-
b) To offset, insert the hexagon wrench
into the socket on the top of the
cuttercase and rotate it. (MA2)
• Replace with new blades when the
tooth width became less than 8mm at
MA2
the tip. (MA1-c)
• As the extent of wear differs by each
tooth depending on use conditions,
rotate the blade position at intervals.
US-14
procedure
wipe out
inspect/clean
see ■ADJUSTING
IDLING SPEED (p.12)
clean and readjust
plug gap
clean
check operation
replace if
something's wrong
make sure to attach
grease
tighten/replace
WARNING
every every every
25 50 100
before hours hours hours
use after after after
✔
✔ ✔
✔
✔
✔
✔
✔
✔
✔
✔
✔ ✔
MA3
note
replace, if necessary
replace carburetor
if necessary
GAP: .025in(0.6~0.7mm)
replace, if necessary
not adjusting screws
To remove blades:
1. Turn over the machine and remove the
bottom cover (MA3-1) by removing the
4 screws.
2. Loosen 4 screws and remove the lower
blade (MA3- 2)
3. Loosen 4 screws and remove the upper
blade (MA3-3),
To install blades:
The upper and lower blades are
interchangeable. When fastening the
blade mounting screws, torque them
uniformly.