Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LIGHTING THE APPLIANCE
1. Read instruction before lighting.
2. When you are sure there are no leaks, turn cylinder
valve and regulator control valve on hose to the closed
position.
3. Reopen cylinder valve fully.
4. Have a standard match, fireplace match or long-nosed
propane lighter lit and ready to place over the burner.
5. Light the burner from the burner top before opening the
gas supply, keeping hands and face away from open
burner.
6. Place lighter over the burner open, then slowly open
regulator valve until burner ignites.
7. Adjust the regulator control valve for desired flame height.
8. When finished using the cooker, turn off gas cylinder valve first. It will take a few second for the fire to go
out and for the propane gas to "bleed" from the hose and regulator assembly. After the fire is completely
out, turn regulator control valve to the "OFF" position.
9. To re-light, repeat steps 1 - 8. Always use CAUTION as cooker will be hot.
10. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the lighting
procedure.
11. If the appliance fails to ignite after the second attempt, call our Customer Service Department at U.S.A:
1-800-913-8999.
BURNER FLAME CHECK
Light Burner, rotate knob from HIGH to LOW. You should see a smaller
flame in LOW position than seen on HIGH. Always check flame prior to
each use. The air damper mounted on the back of your burner (at the
arrow in the image to the right) helps to control the amount of primary
air that mixes with the LP gas. A blue flame with little or no yellow flame
provides the best heat. Adjust the air damper by turning it clockwise or
counterclockwise until the desired flame is achieved.
TURNING LP COOKER OFF
Turn all knobs to OFF position, turn LP tank OFF by turning hand-wheel
clockwise to a full stop.
HOSE ASSEMBLY AND REGULATOR CHECK
Cleaning and inspection of pressure regulator and hose assembly prior to use. If there is evidence of abrasion,
wear, cuts or leaks, the hose assembly must be replaced prior to the appliance being put into operation. The
replacement hose assembly shall be that specified by the manufacturer.
Operating instructions
22
Tabla de contenido
