Klarstein 10032999 Manual Del Usuario página 24

EN
24
Switching the device o and off [On/Off]
Note: When power switch was turned on, the fireplace is in standby status and
indicator is on.
• Press the ON/Off button once, the flame is switched on at level 3 (high) and the
flame symbol lights up in the display.
• Press the ON/OFF key again, all functions are switched off and the device switches
to standby mode.
• Press and hold the ON/OFF button for 3 seconds to clear all settings.
Flame and Ambient Light[Flame]
The flame brightness can be adjusted in 3 steps. The display shows the corresponding
brightness as: [-1] > [-2] > [-3].
• Press the FLAME button once. The flame effect lights up at level 1 and the flame
symbol lights up in the display.
• Press the FLAME button twice. The flame effect lights up at level 2 and the flame
symbol lights up in the display.
• Press the FLAME button three times. The flame effect lights up at level 3 and the
flame symbol lights up in the display.
• Press and hold the Flame button for 2 seconds to turn on the ambient light. Then
press the FLAME button several times in succession to adjust the color of the ambient
light accordingly: Red > Yellow > Green > Purple > Blue > Pink > White.
• Press and hold this button again for 2 seconds to return to the flame brightness
settings.
Heating [Heat]
Note: The heating is influenced by set timers or week timers. If you want to set the
heating manually, make sure that all timers are switched off.
• Press the HEAT button once. The heating runs at 1000 W and the following display
flashes:
• Press the HEAT button twice. The heating runs at 2000 W and the following display
flashes:
• Press the HEAT button three times to turn off the heater.
The HEAT button is used in Adaptive Start, Timer and Weekly Timer modes to confirm
an entry (OK).