Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Electrical Connection
This unit can be connected to an optional CD changer (CX-DP88U). For details consult your
nearest Panasonic Servicenter.
For connection to a CD changer, refer to the operating instructions of the CD Changer
(CX-DP88U).
Cautions:
To prevent damage to the unit, be sure to follow the connection diagram below.
Remove the covering of the leads about 5 mm long from their end before connecting.
Do not insert the power connector into the unit until the wiring is completed.
Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle
all cables and keep cable terminals free from touching any metal parts.
Extension Corel
(DIN/BATT/RCA/GND)
Fuse(3A)
BATTERY
Battery Lead
RCA Cord
(Red)
DIN Cord
Antenna
PREAMP OUT CONNECTOR
(Rear)
SPEAKER LEAD
(Gray w/Black Stripe)
(White w/Black
Stripe)
(White)
(–)
(+)
(–)
(+)
LEFT SPEAKER
RIGHT SPEAKER
(FRONT )
(FRONT )
(L)
(White)
CD Changer
Control Connector
(R)
CQ-RG131U
CD-CH IN
L(White)
R(Red)
Resistor(1kΩ)
(Violet w/Black Stripe)
(Green w/Black
(Green)
(Gray)
Stripe)
(–)
(+)
LEFT SPEAKER
(REAR )
CD Changer
CX-DP88U
Ground Lead
(To a clean, bare metallic
part of your car)
DIN Extension Cord
Power
Connector
(Yellow)
Fuse(12A)
(Red)
(Black)
(Blue)
(Violet)
(–)
(+)
RIGHT SPEAKER
(REAR )
Battery Lead
To the car battery, continuous
+12V DC
ACC Power Lead
to ACC power, +12V DC
Ground Lead
to a clean, bare metallic part of
the car chassis
Antenna Control Cord
to the auto antenna control power
cord of the car
External Amplifier
Control Power Lead
To an external amplifier
CQ-RG131U
E
N
G
L
I
S
H
18
27
Tabla de contenido
