RedMax BCZ2450S Manual De Instrucciones página 20

BCZ2450S/T
12. Optional blade usage (for BCZ2450S only)
■ STARTING THE ENGINE
Please refer 5.For safe operation (P.6),
8.Operation (P.12).
• The product is equipped with a
centrifugal clutch mechanism, so
the cutting attachment could rotate
as soon as the engine is started.
OPT7
When starting the engine, place the
product onto the ground in a flat
clear area and hold it firmly in place
so as to ensure that neither the
cutting part nor the throttle come
into contact with any obstacle when the engine starts. (OPT7)
■ CUTTING METHOD
a) Use the front left side cutting.
b) Guide the blade from your right to left
OPT8
with it tilted slightly to your left. (OPT8)
c) When mowing a wide area, start
working from your left end to avoid
interference of cut grass.
d) The blade may be seized by weeds if
the engine speed is too low, or the
blade cuts too deep into weeds. Adjust
the engine speed and cutting depth
according to the condition of object.
• If the grass or other object gets
caught in the blade, or if the unit
starts to shake or vibrate, turn off
the engine and check the whole unit.
Change the blade if it has been
damaged.
• Turn off the engine and make sure
the blade has completely stop
before checking the blade, and
removing any object got caught in.
■ OPERATION
1. Check the bolt to fasten the blade and
OPT9
be sure the bolt has no fault, and no
abrasion.
2. Be sure that the blade and the holder
have been fastened according to
instruction and the blade turns
smoothly without abnormal noise.
(OPT9)
• The rotating parts fastened
incorrectly may cause serious
accident to the operator.
US-18
WARNING
WARNING
WARNING
• Make sure that the blade is not bent,
warped, cracked, broken or
damaged.
• If you find any error to the blade,
discard it and change new one
which is certified by RedMax.
■ By using the shoulder strap, hang the
OPT10
unit on your right side. Adjust the strap
length so that the cutting head may
become parallel to the ground.
(OPT10)
Make sure to use shoulder strap and debris guard. If not, it is very
dangerous when you slip or lose your
balance.
■ CONTROLLING BLADE THRUST
• Blade thrust can cause serious
personal injury. Carefully study this
section. It is important that you
understand what causes blade thrust,
how you can reduce the chance of
blade thrust and how you can remain in
control of the unit if blade thrust does
occur.
1. What causes blade thrust:
• Blade thrust can occur when the
moving blade contacts an object that it
cannot cut. This contact causes the
blade to stop for an instant and then
suddenly move or "bounce" away from
the object that was hit. The operator
can lose control of the unit and the
blade can cause serious personal injury
to the operator or any person nearby if
the blade contacts any part of the body.
2. How you can reduce the chance of blade
thrust:
a. Recognize that blade thrust can
b. Cut fibrous weeds and grass
c. Be extra prepared for blade thrust if
WARNING
WARNING
happen. By understanding and
knowing about bounce, you can
help eliminate the element of
surprise.
only. Do not let the blade contact
materials it cannot cut such as hard,
woody vines and brush or rocks,
fences, metal, etc
you must cut where you cannot see
the blade making contact such as in