BH FITNESS H919N Instrucciones De Montaje página 11

1.- ASSEMBLY INSTRUCTIONS.-
The assistance of a second person is
recommended when assembling this
unit. Take the unit out of its box and
make sure that all of the pieces are
there Fig.1:
1. (67) Main body; (21) Handlebar;
(37) Handlebar stem; (41) Saddle
post; (40) Horizontal saddle tube; (1)
Saddle; (12) Rear stabiliser bar with
adjustable feet; (16) Front stabiliser
bar with wheels; (68) Left pedal; (11)
Right pedal; (10) Slot head bolt M-10;
(9) Flat washer M 10; (8) Cap nut M
10; Double ended spanner.
2. Position the machine's rear stand
on the rear stabiliser bar (12), as
shown in Fig.2, insert the bolts (10), fit
the flat washers (9) and cap nuts (8)
and then tighten securely.
Position the front stabiliser bar with
wheels (16), paying attention to the
red dots and with the wheels facing
forwards, as shown in Fig.2, insert the
bolts (10), fit the flat washers (9) and
cap nuts (8) and tighten securely.
2.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal (11), marked
with the letter (R), screws onto the
right-hand crank, also marked with an
(R), in a clockwise direction. Tighten
securely, Fig.3.
The left-hand pedal (68), marked with
the letter (L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.3.
3.- ATTACHING THE SADDLE.-
Fit the saddle bracket (1), Fig.4, onto
the horizontal saddle tube (40), as
shown in Fig.4, fit the saddle into
position and tighten the nuts on the
bracket securely. Next insert the
horizontal saddle tube (40) through
the hole on the saddle post (41), Fig.4,
position it correctly and tighten the
knob (S), Fig.4.
Insert the saddle post (41) into the
boss on the main body (67), position it
correctly and tighten the saddle post
by using the adjustment knob (T),
Fig.4, turning it clockwise.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob (T)
anticlockwise, Fig.4, move the saddle
to a position comfortable for doing
exercise and
adjustment knob (T) securely by
turning it clockwise.
HORIZONTAL
THE SADDLE.-
Loosen the knob (S) slightly by turning
it anticlockwise, Fig.4, move the
saddle to a position comfortable for
doing exercise and then tighten the
knob (S) securely by
clockwise.
4. FITTING
HOLDER.-
Loosen off the two bolts on the
handlebar assembly and position the
bottle holder (29) then tighten up (Fig.
4).
7
direction.
slightly by turning
then tighten
ADJUSTMENT
turning
THE BOTTLE
Tighten
it
the
OF
it