Sewing Buttons - Brother 885-X36 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

SEWING BUTTONHOLES AND BUTTONS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
If the left side is too open, turn the buttonhole
fine-adjustment screw with a large
screwdriver in the
If the left side is too tight, turn the buttonhole
fine-adjustment screw with a large
screwdriver in the
• This adjustment ensures both sides of the
buttonhole are the same.

Sewing buttons

Stitch
Stitch
Length
Pattern
Name
[mm
(inch)]
3
Zigzag
F
Stitch
(1/64)
Measure the distance between the
1
buttonholes and mark the fabric. Then
adjust the stitch width so that it is the
same as the distance between the holes in
the button.
Raise the presser foot lever, and then slide
2
the feed dog position switch to
page 15).
Turn off the machine.
3
Change the foot to the button sewing foot
4
"M".
Turn on the machine.
5
CAUTION
Do not turn on the machine while
pressing down the foot controller. The
machine may start unexpectedly and
cause personal injury or damage to the
machine.
41
"–"
direction.
"+"
direction.
Stitch
Width
Foot
[mm
(inch)]
Button sewing
Any
foot "M"
(see
Put a button between the foot and the
6
fabric and make sure that the needle enters
the holes without hitting the button. If it
hits, see step
.
1
At a slow speed, sew about 10 stitches.
7
CAUTION
Make sure the needle does not hit the
button during sewing. The needle may
break and you may be injured.
Pull the upper thread at the end of the
8
stitching to the wrong side of the fabric,
and then tie it with the bobbin thread.
Use scissors to cut the upper thread and
the bobbin thread at the beginning of the
stitching.
When you are finished attaching the
9
button, slide the feed dog position switch
to
(see page 15), and turn the
handwheel to raise the dogs.
Memo
● The feed dog position switch is normally set
to the right side.
● The feed dogs come up when you start
sewing again.

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

885-x38885-x39888-x36888-x38888-x39

Tabla de contenido