Rectifying Malfunctions - Hoberg ASYHT0518020 Traducción Del Manual De Instrucciones Original

EN
• The specifi ed total vibration value and the specifi ed noise emission values have
been measured using a standardised testing method and can be used to compare
one power tool with another one. The emission values can also be used to make a
preliminary assessment of the level of pollution.
• The vibration and noise emissions may vary from the specifi ed values when the
power tool is actually used, depending on the way in which the power tool is used,
in particular what kind of workpiece is being machined.
Please note: The information about noise and vibrations specifi ed in the Technical Data
is determined in accordance with EN 60745 / DIN EN 62841-1 or comparable inter-
national standards. The values specifi ed relate to normal use of the tool under normal
working conditions. Poorly maintained, incorrectly fi tted and inappropriately used tools
may display higher sound levels and vibration values. You can fi nd more information
about the EU Vibration Directive and about levels of exposure to noise and vibrations,
which may also be relevant to DIY enthusiasts, on the website of the European Agency
for Safety and Health at Work: www.osha.europa.eu.

Rectifying Malfunctions

Users of this device may only carry out care and maintenance tasks that are described
in these operating instructions. Only authorised distributors may carry out more com-
plicated repairs.
Fault
The device does not start
up when it is switched on.
22
Cause
No electrical contact
between the device and
the battery
Battery charge level too
low
Battery too hot / cold
Fault in the battery
Device too hot
Electromagnetic fault or
error in the device
Moisture in the device or
battery
Fix
Remove the battery,
perform a visual check of
the contacts and insert it
again
Charge up the battery
Allow the battery to warm up
or cool down if necessary
Remove the battery from
the device and reinsert
it; if the device still does
not start up, the battery is
defective and needs to be
replaced
Allow the device to cool
down
Remove the battery from
the device and reinsert
it, switch the device on
again; if it still does not
start up, the device is
defective and needs to be
replaced
Allow the device and bat-
tery to dry