4 Operation
• Set the sliding switch for automatic
operation to "ON/AUTO".
The „READY" display glows.
ON
OFF
REV
• Feed in the paper to be shred-
ded, however, never feed in
more than 5 sheets at a time.
The cutting device starts auto-
matically, pulls in the paper and
shreds it.
When the feed opening is
clear of paper again, the cutting
device switches off.
Swit ching paper shredder off
• Set the sliding switch to "OFF".
ON
OFF
REV
5 Troubleshooting
Paper jam
• Set the slider switch to "REV".
Pa per is pus hed out.
• Set the slider switch to "ON/AUTO"
ON
OFF
REV
again.
• Do not feed in too many sheets at
once.
Shredded material container
Check the level in the shredded material contai-
ner and empty it in good time, as otherwise the
function of the cutting device could be impaired.
For all other malfunctions, check whether the
cutting head was correctly positioned on the
shredded material container before contacting
our customer service. If the motor was over-
loaded, let the shredder cool down for 15 to
20 minutes before using it again.
8
6 Cleaning and care
Switch off the shredder and pull out the mains
plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must
enter the equipment.
After approx. every 100 working cycles, spray
standard, commercially-available, special clean-
ing oil for shredders through the feed opening
over the entire width of the cutting device. Let
the cutting device run backwards several times
in the „REV" setting without feeding in any
paper. This loosens paper dust and particles.
7 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
02/2011