Front Runner FAJT001 Manual Del Usario página 4

2
FIT AND SECURE
2.1
2.2
2.3
FAJT001 / FAJT002_REV_A00
4
Looking at the roll cage at the rear
passenger door, remove the plastic trim
covers located on the inside of the roll bar as
shown.
T25
Do this on both the left and right side.
Remove the speaker box located above the
front seats.
10mm
Before fitting the rear Inner Brackets (Item
1), insert the M8 Cage Nuts (Item 14).
Refer to Figure 1.1 for assembly of the Cage
Nuts.
Locate the back hole shown on the
13mm
underside of the roll bar, at the rear
passenger door.
Fit the Inner Brackets on top of the roll bar
and loosely secure them to the roll bar using
M8 x 100 Hex Bolts, M8 SS Spring Washers
and M8 x 19 x 2SS Flat Washers (Items 15,
16 & 17) as shown.
Refer to Figure 1.1 again if necessary.
Do this on both the left and right side.
Using the two top holes on the Inner Bracket
as a guide, mark the hole positions on the
roof. Do the same with the opposite side.
You will drill these in 2.4.
4 © 2020 FRONT RUNNER VEHICLE OUTFITTERS