Maintenance And Inspection - HIKOKI CV 12DA Instrucciones De Manejo

MOUNTING AND OPERATION
Action
Removing and inserting the
battery
Charging
Remaining battery indicator
Switch Operation
How to use the LED light
Adjusting operating speed
Mounting the application tool
Housing the hexagonal bar wrench
Holding the tool
Sawing
*2
Sanding
*2
Mounting dust collection adapter
(sold sepalately)
Selecting accessories *3
*1 You can change the vibration frequency between 6000
to 20000 min -1 by adjusting the dial from "1" to "6".
Adjust the dial for the speed that best suits your task
conditions and materials.
*2 Avoid applying excessive force to the tool. Avoid
applying pressure to the battery while working.
*3 Select accessories that are suited to a specifi c task.
For details contact HiKOKI Authorized Service Center.
Safeguard Function
Overload Protection
Temperature Protection
Low Voltage Protection
Damage to PCBA parts

MAINTENANCE AND INSPECTION

1. Inspecting the application tool
Continued use of a dull or damaged application tool
will result in reduced cutting effi ciency and may cause
overloading of the motor. Replace the application tool
with a new one as soon as excessive abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Cleaning on the outside
When the power tool is stained, wipe with a soft dry cloth
or a cloth moistened with soapy water. Do not use chloric
solvents, gasoline or paint thinner, for they melt plastics.
5. Storage
Store the power tool in a place in which the temperature
is less than 40°C and out of reach of children.
Figure Page
2 2
3 2
4 2
5 2
6 3
*1 7 3
8 3
9 4
10 4
11 4
12 4
13 5
― 172
LED Light Display
On 0.5 second/off 0.5 second
On 0.25 second/off 0.25 second
LED LIGHT WARNING SIGNALS
This product features functions that are designed to protect
the tool itself as well as the battery. While the switch is
pulled, if any of the safeguard functions are triggered
during operation, the LED light will blink as described in
Table 3. When any of the safeguard functions are triggered,
immediately remove your fi nger from the switch and follow
the instructions described under corrective action.
Table 3
Remove the case of the overloading.
Allow the tool and battery to thoroughly cool.
Recharge the battery.
Please take the tool to the HiKOKI
Authorized Service Center.
NOTE
Storing lithium-ion batteries
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries with
a low charge may result in performance deterioration,
signifi cantly reducing battery usage time or rendering
the batteries incapable of holding a charge.
However, signifi cantly reduced battery usage time may
be recovered by repeatedly charging and using the
batteries two to fi ve times.
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries dead
and purchase new batteries.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
11
English
Corrective Action