Control Panel - HAEGER IM-18S.004B Instrucciones De Uso

Main power connection
Warning: Improper use of the grounded plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by an authorized service.
•
Before plugging the appliance into the mains socket, check that:
– The mains power supply corresponds to the working voltage indicated on the rating plate.
– The power socket and electrical circuit are adequate for the appliance.
–
The power socket matches the plug. If this is not the case, have the plug replaced by a qualified
electrician.
–
The mains socket is adequately earthed.
•
Do not cut or remove the ground wire from the power cord supplied under any circumstances.
•
Use of extension cords is not recommended.
Operation
Before/First Use of Your Ice Maker
1. During transportation, the incline angle of the cabinet should not be over 45°. Do not turn the Ice
maker upside down. As this may damage the compressor and sealed system.
2. Remove all packing material and carefully check your ice maker to ensure it is in good condition and
that there is no damage to the ice maker or power cord and plug.
3. The Ice maker should be placed horizontally on a level surface. To ensure proper ventilation for your
Ice maker allow 15cm of space at the top, the back and on each side. Do not install the Ice maker
near an oven, radiator, or any other heat source.
4. Before using the Ice maker for the first time, please wait 2 hours after positioning it, and keep the
front lid open for at least 2 hours.
5. Ensure that the voltage indicated on the ice maker corresponds with the voltage in your home.
6. Pure water is not allowed to be used on this unit, spring water is recommended.

Control Panel

START: Press to turn unit on.
STOP: Press to turn unit off.
SELECT: Ice size selection, Small, Medium or Large. (The selected mode shall stay as selected unless
changed or there is a power failure). The default setting is medium.
ADD WATER: This light will come on with a long beep tone. You will need to add water and press STOP
and then START button to restart the ice maker.
ICE FULL: This light will come on with two beep tones when the ice has reached the maximum capacity of
the storage cabinet. Press STOP and then START button to restart the ice maker after some of the ice
has been taken away.
Instructions for use
English
3