Tabla de contenido
R
TROUBLESHOOTING CUTTING CONDITIONS (CONT'D)
CONDITION
U N E v E N C U T O N F L AT
GROUND - WAvY HIGH-LOW
APPEARANCE, SCALLOPED
CUT, OR ROUGH CONTOUR
Width of Deck
UNEvEN CUT ON UNEvEN
GROUND - WAvY APPEARANCE,
HIGH-LOW SCALLOPED CUT,
OR ROUGH CONTOUR
Width of Deck
SLOPING RIDGE ACROSS
WIDTH OF CUTTING PATH
Width of Deck
CAUSE
Lift worn from blade
Blade upside down
Deck plugged, grass accumulation
Too much blade angle (deck pitch)
Deck mounted improperly
Bent spindle area
Dull blade
SGB020
Uneven ground
SGB021
Tire pressures not equal
Wheels uneven
Deck mounted incorrectly
Deck not level side-to side
SGB023
Replace blade
Mount with cutting edge toward ground
Clean underside of deck
Adjust pitch and level
See your authorized SCAG dealer
See your authorized SCAG dealer
Sharpen blade
May need to reduce ground speed, raise
cutting height, and/or change direction
of cut
Check and adjust tire pressure
Check and adjust tire pressure
See your authorized SCAG dealer
Check for level and correct
16
Section 5
CURE
Tabla de contenido
