Tabla de contenido
MA6
MA7
38
English
9. Maintenance
■ GEAR CASE (MA6)
• The reduction gears are lubricated by multipurpose,
lithium-based grease in the gear case. Supply new
grease every 25 hours of use or more often
depending on the job condition.
• Remove the side bolt in gearcase opposite of grease
nipple before installing new grease to arrange for old
grease to exit.
■ INTAKE AIR COOLING VENT
WARNING
• Never touch the cylinder, muffler, or spark plugs
with your bare hands immediately after stopping
the engine. The engine can become very hot
when in operation, and doing so could result in
severe burns.
• When checking the machine to make sure that it
is okay before using it, check the area around
the muffler and remove any wood chips or
leaves which have attached themselves to the
brushcutter. Failing to do so could cause the
muffler to become overheated, and that this in
turn could cause the engine to catch on fire.
Always make sure that the muffler is clean and
free of wood chips, leaves, and other waste
before use.
• Check the intake air cooling vent and the area
around the cylinder cooling fins after every 25 hours
of use for blockage, and remove any waste which
has attached itself to the brushcutter. Note that it is
necessary to remove the engine cover shown in
(MA7) in order to be able to view the upper part of
the cylinder.
IMPORTANT
• If waste gets stuck and causes blockage around the
intake air cooling vent or between the cylinder fins, it
may cause the engine to overheat, and that in turn
may cause mechanical failure on the part of the
brushcutter. (MA7)
(1) Cylinder
(2) Intake air cooling vent (back)
Tabla de contenido
