Tabla de contenido
OP1
OP2
(6)
(7)
(5)
OP3
26
English
8. Operation
■ STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine
starts.
1. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
2. Push the primer pump several times until overflown
fuel flows out in the clear tube. (OP1)
3. Move the choke lever to the closed position. (OP1)
4. Set the ignition switch to the "Start" position. Make
sure that the throttle is at the idle position. (OP2)
5. While holding the unit firmly, pull out the starter rope
quickly until engine fires. (OP3)
(1) Primer pump
(3) Close
(5) Ignition switch
(7) Stop
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
6. Move the choke lever downward to open the choke.
And restart engine. (OP1)
7. Allow the engine to warm up for several minutes
before starting operation.
NOTE
1. When restarting the engine immediately after
stopping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
■ STOPPING ENGINE (OP2)
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the "Stop" position.
(2) Choke lever
(4) Open
(6) Start
Tabla de contenido
