Parts List - Reese Explore 63124 Guía De Instrucciones

ASSEMBLY INSTRUCTIONS

PARTS LIST

Tools required for assembly: 5/16" Wrench or
Socket, 11/16" Wrench
ASSEMBLING THE CARRIER:
1. Position bike cradles (C) onto top plate of carrier as shown in Fig 1 and
secure with M6x1 x 14mm screws (D) using the supplied allen wrench
(J).
2. Assemble both tubular sections together (A, B) as shown and fasten
together with (2) 5/16" x 2-1/2" carriage bolts (E) and 5/16-18" lock nuts
(F). Tighten to 17 ft-lb. Fig 1.
3. With bike carrier in upright position, install "bail lock pin" through hole
in side plates and upright tube. Secure pin by hooking bail wire over
end of pin. Fig 2.
4. Place bike carrier receiver into your receiver hitch. Secure carrier
with 5/8" anti-rattle pin (G), 5/8" lock washer and clip (I). Fig 1.
Note: This will only fit a 2" receiver.
2
Bail Pin
PART DESCRIPTION
A Tubular Section, Top
B Tubular Section, Bottom
C Bike Cradle With Straps
M6x1 x 14mm Button Head Cap
D
Screw
E 5/16-18x2-1/2" Carriage Bolt
5/16-18" Lock Nut
5/8" Anti-Rattle Pin
H
I
5/8" Lock Washer
Clip
PAGE 2 63124_IN_Rev B • Questions? (800) 234-6992 • ReeseBrands.com
QTY. PART DESCRIPTION
1 F 5/16-18" Lock Nut
1 G 5/8" Anti-Rattle Pin
4 H 5/8" Lock Washer
8 I Clip
2 J 4mm Allen Wrench
1
J
4mm Allen Wrench
C
Bike Cradle With Straps
A
Tubular Section, Top
F
5/16-18x2-1/2" Carriage
G
B
Tubular Section, Bottom
Bail Pin
QTY.
2
1
1
1
1
D
M6x1 x 14mm Button
Head Cap Screw
E
Bolt