Cleaning And Maintenance; Cleaning - Svan SVH385X Manual De Usuario

Ocultar thumbs Ver también para SVH385X:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. CLEANING AND
MAINTENANCE

5.1 Cleaning

WARNING: Switch off the appliance
and allow it to cool before cleaning is
to be carried out.
General Instructions
Check whether the cleaning materials
are appropriate and recommended by
the manufacturer before use on your
appliance.
Use cream cleaners or liquid cleaners
which do not contain particles. Do not
use caustic (corrosive) creams, abrasive
cleaning powders, rough wire wool or
hard tools as they may damage the
cooker surfaces.
Do not use cleaners that contain
particles as they may scratch the
glass, enamelled and/or painted parts
of your appliance.
Should any liquids overflow, clean them
immediately to avoid parts becoming
damaged.
Do not use steam cleaners for
cleaning any part of the appliance.
Cleaning the Inside of the Oven
The inside of enamelled ovens are best
cleaned while the oven is warm.
Wipe the oven with a soft cloth soaked
in soapy water after each use. Then,
wipe the oven over again with a wet
cloth and dry it.
You may need to use a liquid cleaning
material occasionally to completely
clean the oven.
Cleaning the Glass Parts
Clean the glass parts of your appliance
on a regular basis.
Use a glass cleaner to clean the inside
and outside of the glass parts. Then,
rinse and dry them thoroughly with a dry
cloth.
Cleaning the Stainless Steel Parts (if
available)
Clean the stainless steel parts of your
appliance on a regular basis.
Wipe the stainless steel parts with a soft
cloth soaked in only water. Then, dry
them thoroughly with a dry cloth.
Do not clean the stainless steel parts
while they are still hot from cooking.
Do not leave vinegar, coffee, milk, salt,
water, lemon or tomato juice on the
stainless steel for a long time.
Removal of the Inner Glass
You must remove the oven door glass
before cleaning, as shown below.
1. Push the glass in the direction of B and
release from the location bracket (x). Pull
the glass out in the direction of A.
To replace the inner glass:
1. Push the glass towards and under the
location bracket (y), in the direction of B.
3. Place the glass under the location
bracket (x) in the direction of C.
EN - 20
A
x
B
B
y
Tabla de contenido
loading

Tabla de contenido