Configuration - Tripp-Lite SRWO8U22 Manual Del Propietário

Installation/Wall-Mounting
12U Configuration
Step
Insert one end of the longer vertical mounting rails into the corners of the bottom
1
panel frame (both panel frames can be used as a top or a bottom) opposite the
mounting side and secure them with 2 of the M5 x 10mm Phillips head screws on
each side.
Step Insert the other end of the longer vertical mounting rails into the corners of the
2
top panel frame opposite the mounting side and secure them with 2 of the M5 x
10mm Phillips head screws on each side.
Step Attach the right-side and left-side support straps by securing 8 of the M6 x 12
3
Phillips head screws to the sides of the top panel frame and vertical mounting rails.
Step Before mounting the rack, find the studs in your wall/mounting surface and make
4
all measurements, and or guide marks in accordance with the configuration you
have chosen (12U).
Step Using user-supplied hardware, mount the top and bottom panel frames to the wall.
5
Both mounting frames can accommodate 5/16" lag bolts.
Step Using the supplied zip ties included in the expansion hardware bag, you can
6
store the extra 8U (short) mounting rails, plus the remaining expansion hardware
contents (Mounting Rail Tie Plates, 8 M5 Phillips Screws and Zip Ties) inside
the bag that the expansion hardware was packaged in. It is important to save all
unused hardware in the event that you want to expand your configuration at a later
date.
continued
4
1
2
3
5
6
16"
(406.4 mm)
22.75"
(577.8 mm)
Store Expansion
Parts Here