Tabla de contenido
A06113901_rev1SanitaireProS5000A.qxp_Layout 1 8/24/18 9:57 AM Page 6
How to assemble
ENGLISH
• Remove all parts from carton and
identify each item shown. Make sure all
parts are located before disposing of
packing materials.
• Place the brushroll /nozzle head on a flat
surface with the neck and the support
lever in the upright position.
• Hold the dust bag housing vertically
and place over neck and support lever
(Fig. 1). Push dust bag housing down
firmly to lock into place.
• Lift the handle lock. Insert the handle
assembly into the top of the dust bag
housing and push down firmly (Fig.2).
When the handle assembly is inserted
as far as it will go, press the handle lock
down until it clicks.
Note: If the handle is not pushed
completely down, the vacuum cleaner
will not start.
• Insert wand with handle grip and hose
into the channel at the back of the
machine. Place handle grip over tab to
latch into position (Fig. 3). Smooth end
of hose; should fit loosely into wand.
• Push remaining hose end into hose
inlet. The inlet clip will lock the hose into
place when fully inserted (Fig. 4).
Squeeze the clip on both sides to
remove the hose (Fig. 5).
• Snap dusting brush into clip on front
of handle.
• Check placement of the crevice tool and
upholstery tool. Both tools fit into
recesses in the back of the cleaner.
• Push cord into cord clip on handle. Wrap
the cord around upper and lower cord
retainers.
6
www.sanitairecommercial.com
What's in the carton
Contenu de la boîte
Contenido de la caja
1
3
2
4
Rear view
5
Tabla de contenido
