Use; Lighting; Operation; Periodic And Continuous Use - deville C07762 Guía De Utilización

With the ash box and loading door closed hermetically, the adjustment is performed using the
thermostat knob.
Maximum heating is obtained with thermostat in position 8.
For slow burning: the index must be set on position 0.
. Adjusting the thermostat flap (Fig. 10) :
Adjustment is factory-set. However, we recommend checking it before first lighting.
For a 20° C room temperature, when the control lever is on position 0, the gap between the
supporting plate and the flap must be zero (cold appliance).
However, the flap must be subjected to no thrust, it must lift from its supporting plate when the
knob is set to position 1.
If required, to obtain this operating mode, change the flap adjustment by acting upon the
adjustment knob : access inside the ash box compartment.
- The poker handle (15) (Fig. 11) required for opening the ash box door, as well as for oving the
logs inside the stove.
- Opening the Control door (Fig. 12) :
. C07762 : with hands
. C07782 : with the poker handle (15)
. C07785 : with the cool handling tool (16)
. C07789 : with the poker handle (15)
. C07799 : with the poker handle (15)
- The scraper (Fig. 13) : for de-ashing and cleaning the appliance.
Do not burn your hands uselessly. Use the accessories.

4.4 USE

4.4.1 Lighting

- Turn the thermostat to position 8.
- Place crumpled paper on the grating and very dry kindling wood (twigs), then larger cross-
section cut wood (diameter 3 to 5 cm).
- Light the paper and close the door (leave it partly open to accelerate lighting up).
- Once the "kindling wood" load is burning, open the door, load the appliance with the
recommended fuel and use the regulation devices to obtain the burning required.

4.4.2 Operation

4.4.2.1 Periodic and continuous use

- The intermittent use of the appliance requires a reload every 45 minutes.
This type of use is particularly recommended as it environmentally friendly.
- The apparatus may also be used in continuous mode when periodic use is not possible or when
reduced burning is required. In this case, maximum heat output can be maintained for 3 hours and
with a slow combustion rate, and a low heat output, the burning period can extend to 10 hours with a
9 kg load.
(13) Adjustement knob
(14) Flap
16