Brief Description Of The Press Device - NovoPress ACO102 Instrucciones De Uso

ACO102
The stated vibration emission value was measured using a standard test procedure and can be employed for the
EN
purpose of comparison with another device.
The stated vibration emission value can also be used to obtain an initial estimate of interruptions during intermittent
operation.
Caution: The vibration emission value may differ from the stated value while the device is actually in use, depending
upon the manner in which the device is used. It may be necessary to establish safety measures to protect operating
personnel, depending on the actual conditions of use (intermittent operation).
Battery charger
For information on the function and operation of the battery charger and the rechargeable batteries,
please consult the battery charger operating instructions.
7

Brief description of the press device

7.1 Automatic press cycle (Fig. 1)
The device features an automatic press cycle. This ensures that the pressing operation is always
completed. The automatic press cycle is only activated after approx. 1 second. After the automatic press
cycle has been triggered, the green LED (2) goes out and the pressing operation runs automatically. The
pressing operation can then only be stopped by pressing and holding release button (5). After the
pressing operation has been completed, the motor automatically switches off and the green LED (2) lights
up again.
If the start button (1) is released before the automatic press cycle begins, the piston in the press device
moves back to its starting position. The pressing operation will not have been completed. The pressing
operation must be triggered again.
7.2 Rotatable head
The press tool is equipped with a rotatable crimping head. The head is rotatable by 180°. Within the
range of these 180° the crimping head can be moved into any position. It is only possible to adjust the
crimping head before the pressing operation. The crimping head cannot be rotated while the pressing
operation is being performed.
7.3 Release button (Fig. 1)
The pressing operation can be stopped at any time by pressing and holding the release button (5). The
piston in the press device then returns to its starting position.
7.4 Battery
Removing the battery (Fig. 2)
Push in (1) the two release buttons (A) and then remove the battery (2).
Inserting the battery (Fig. 3)
Slide the battery into the device as illustrated until it clicks into place.
Battery charge indicator (Fig. 2)
The 4 green LEDs (4) indicate the charge level of the battery. The number of LEDs lit up denotes the
battery charge. If the LED (2) is flashing, the battery is empty and no further travel is possible.
7.5 ACO102 and battery
Information
The ACO102 press device must only be operated with 12 V lithium-ion
rechargeable batteries. The 12 V battery must only be used in the appropriate
press devices.
Information
The batteries are not charged at the factory.
Therefore:
– Charge the batteries before using for the first time.
Information
Limited temperature range for charging and storing the batteries.
Therefore:
– It is imperative that the operating instructions for the battery charger are complied with.
12