GENERGY Sella Instrucciones De Uso página 25

GAS POWERED PRESSURE WASHER
Follow these instructions to operate the machine:
1. Use the pre-operation checklist to help avoid personal injury.
2. Prime the pump and purge air from the system by squeezing the gun trigger before starting the
machine with the unit attached to a pressure main. Let the water flow from the wand until air is
purged from system.
3. If engine is equipped with fuel valve, turn valve to ON.
4. Close choke lever located on engine carburetor as per engine manufacturer instructions.
5. Turn engine switch to ON.
6. i f engine is equipped with throttle lever, position lever to half throttle.
7. For easier starting, squeeze the trigger on the spray gun allowing water to pass through gun and
grasp the engine starter grip. Pull lightly on the starter grip until resistance is felt, then pull briskly.
Repeat this step as necessary until engine starts.
8. As engine begins to warm up, gradually move the choke lever to open.
9. If engine is equipped with throttle lever, position lever to full throttle.
10. The manufacturer has adjusted the pump pressure to its maximum operating pressure. Simply adjust
the pressure required for cleaning with the nozzle as follows when your wand is equipped with:
Quick Connection Nozzles. Change nozzles to desired spray pattern (0°,15°,25°,40°) or detergent
nozzle (the one with the larger orifice) by quick coupling. DO THIS ONLY WHEN THE TRIGGER
IS NOT SQUEEZED AND THE GUN SAFETY IS ON.
11. You are now ready to start cleaning with your pressure washer. Hold the spray gun firmly and squeeze
the trigger. CAUTION: NEVER POINT THE SPRAY GUN AT PEOPLE, ANIMALS OR PLANTS.
Always begin high pressure washing with the nozzle at least four feet from the object being cleaned
and gradually move nozzle closer to the object until it is cleaned without damage.
12. To draw chemical/detergent, be sure the pick up tube is installed into the chemical/ detergent container
with the tube submerged in the solution. Change quick connection nozzle to the detergent nozzle
and squeeze the gun trigger. Adjust the knob counterclockwise until proper chemical application is
reached. (Picture below is for reference only.)
13. Never allow the pump to run for more than a 3 minute period without opening the gun. This will cause
damage to the pump due to excessive water temperature and will void the warranty. (A thermal relief
valve has been added to the pump in some models to reduce the possibility of overheating, however,
malfunction of this device does not constitute pump warranty for damage caused by overheating.)
14. As you operate the machine, be sure the inlet garden hose does not become kinked.
It is prohibited to reproduce, copy or use this document without written permission from Stock Garden Spain (GENERGY), Spain, 2009.
Adjusting
Soap Injector
25